(321) 800-3377

Office Hours: Weekdays 8AM-4PM

Resilient Flooring

Homeowner Use and Maintenance Guidelines

Although resilient floors are designed for minimum care, they do have maintenance needs. Follow any manufacturer's specific recommendations for care and cleaning. Some resilient floors require regular application of a good floor finish. This assures you of retaining a high gloss. However, avoid cleaning or finishing agents on the new floor until the adhesive has been thoroughly set. This will take about two weeks.


Color and Pattern

Your color selection sheets provide a record of the brand, style, and color of floor coverings in your home. Please retain this information for future reference.


Limit Water

Wipe up spills and vacuum crumbs instead of washing resilient floors frequently with water. Limit mopping or washing with water; excessive amounts of water on resilient floors can penetrate seams and get under edges, causing the material to lift and curl.

Moving Furniture

Moving appliances across resilient floor covering can result in tears and wrinkles. Install coasters on furniture legs to prevent permanent damage. If you damage the resilient floor, you can have it successfully patched by professionals. If any scraps remain when the installation of your floor covering is complete, we leave them in the hope that having the matching dye lot will make such repairs less apparent.


No-Wax Flooring

The resilient flooring installed in your home is the no-wax type. No-wax means a clear, tough coating that provides both a shiny appearance and a durable surface. However, even this surface will scuff or mark. Follow the manufacturer's recommendations for maintaining the finish.


Raised Nail Heads

Raised nail heads are the result of movements of the floor joist caused by natural shrinkage and deflection. We have used special nails and glued the underlayment to help minimize this movement. If a nail head becomes visible through resilient flooring, place a wood block over it and hit the block with a hammer to reset the nail.


Scrubbing and Buffing

Frequent scrubbing or electric buffing is harder on floors than regular foot traffic. Use acrylic finishes if you scrub or buff.



Any brand or type of resilient flooring may separate slightly due to shrinkage. Seams can lift or curl if excessive moisture is allowed to penetrate them. You can use special caulking at tub or floor joints to seal seams at those locations. Avoid getting large amounts of water on the floor from baths and showers.


Parasol Properties Limited Warranty Guidelines

We will confirm that resilient floor covering is in acceptable condition during your orientation. The Parasol Properties limited warranty does not cover damage to resilient floors caused by moving furniture or appliances into the home. We can assist you in contacting professionals who can repair such damage if it occurs in your home. Parasol Properties is not responsible for discontinued selections.



A resilient floor covering should adhere. Parasol Properties will repair lifting or bubbling and nail pops that appear on the surface.


Parasol Properties has sanded and filled the underlayment joints to minimize the possibility of ridges showing through resilient floor coverings. Ridging is measured by centering a 6-inch straight edge perpendicular to the ridge with one end tight to the floor. If the opposite end of the straight edge is 1/8 inch or more from the floor, Parasol Propertieswill repair this condition.



Seams will occur and are sealed at the time of installation. Parasol Properties will correct gaps over 1/16 inch where resilient flooring pieces meet or 1/8 inch where resilient flooring meets another material. Parasol Properties will correct curling at seams unless caused by excessive water.